Eizo FlexScan S2031W - Manual (Page 6)

4
English
Troubleshooting Setting/Adjustment Prior to use Installation
Connecting Cables
Attention
• When replacing the current monitor with a S2031W/S2431W monitor, be sure to change the PC settings
for resolution and vertical frequency to those which are available for the S2031W/S2431W monitor
referring to the resolution table (back of cover page) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User’s Manual on the CD-ROM.
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
3
Plug the power cord into a power outlet and the Power connector on the monitor.
Connectors on
the PC
DVI connector
D-Sub mini 15-pin
connector
Connectors on
the monitor
DVI-I connector
D-Sub mini 15-pin
connector
Stereo mini jack cable (supplied)
Signal cable MD-C87 (supplied)
Digital connection
Analog connection
CD player, etc
Signal cable FD-C39 (supplied)
Audio output
connector
Audio input
connector
Covering the Monitor Cables
Cover the monitor cables with the cable holder.
Cable holder
Height adjustable stand EZ-UP stand