Connecting cables, Adjusting screen height and angle – Eizo FlexScan S1961 User Manual

Page 6

Advertising
background image

4

English

Troubleshooting

Setting/Adjustment

Prior to use

Installation

Connecting Cables

Attention

• When replacing the current monitor with an monitor, be sure to change the PC settings for resolution and

vertical frequency to those which are available for the monitor referring to the resolution table
(Specifi cations Sheet on the CD-ROM) before connecting the PC.

NOTE
• When connecting two PCs to the monitor, refer to the User’ s Manual on the CD-ROM.

1

Check that the monitor and the PC are powered off.

2

Connect the monitor to the PC with a signal cable that matches the connectors.

After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.

3

Plug the power cord into a power outlet and the Power connector on the monitor.

Connectors on

the PC

DVI-D connector

D-sub mini 15-pin

connector

Connectors on

the monitor

DVI-D connector

D-sub mini 15-pin

connector

Stereo mini jack cable (supplied)*

1

Signal cable MD-C87 (supplied)

Digital connection

Analog connection

CD player, etc

Signal cable FD-C39 (supplied)

Audio output

connector

Audio input

connector*

1

*

1

Speaker applied model

Adjusting Screen Height and Angle

Adjust the screen height, tilt and swivel the screen to the best condition for working.

Attention

Hold left and right edge of the monitor with both hands to adjust the screen up, down, left and right
directions.

Advertising