FIAT Sedici - Manual (Page 162)

158
77J021
77J028 Gearshift lever positions
4- Speed Automatic Transaxle
USING THE
TRANSAXLE
4-SPEED AUTOMATIC
TRANSAXLE
Gearshift lever
The gearshift lever is designed so that it
cannot be shifted out of the “P” position
unless the ignition switch is in the “ON”
position and the brake pedal is depressed.
Always depress the brake
pedal before shifting from
“P” (Park) (or “N” (Neutral) if the ve-
hicle is stationary) to a forward or re-
verse gear, to help prevent the vehi-
cle from moving unexpectedly when
you shift.
WARNING
N (Neutral)
Use this position for starting the engine
if the engine stalls and you need to restart
it while the vehicle is moving. You may al-
so shift into Neutral and depress the brake
pedal to hold the vehicle stationary dur-
ing idling.
D (Drive)
Use this position for all normal driving.
With the gearshift lever in “D” range you
can get an automatic downshift by pressing
the accelerator pedal. The higher the ve-
hicle speed is, the more you need to press
the accelerator pedal to get a downshift.
3 (Low 3)
Use this position for driving on moder-
ate uphill and downhill gradients. The en-
gine braking effect on moderate downhills
can be used in this position. The transaxle
shifts up only to 3rd gear.
2 (Low 2)
Use this position to provide extra power
when climbing hills, or to provide engine
braking when going down hills.
L (Low 1)
Use this position to provide maximum
power when climbing steep hills or driving
through deep snow or mud, or to provide
maximum engine braking when going
down steep hills.
Use the gearshift lever positions as de-
scribed below:
P (Park)
Use this position to lock the transaxle
when the vehicle is parked or when start-
ing the engine. Shift into Park only when
the vehicle is completely stationary.
R (Reverse)
Use this position to reverse the vehicle
from stop. Make sure that vehicle is com-
pletely stationary before shifting into Re-
verse.
151-170 SEDICI LUM FL GB 1ED 10-10-2011 14:27 Pagina 158