HONDA 2011 Accord Crosstour - Manual (Page 155)

To load or play discs, the ignition
switch must be in the ACCESSORY
(I) or ON (II) position.
You operate the disc changer with
the same controls used for the radio.
To select the disc changer, press the
CD/AUX or CD button. You will see
‘‘CD’’ in the display. The disc and
track numbers, and the elapsed time
are shown in the display. You can
also select the displayed information
with the TITLE button (see page
). The system will continuously
play a disc until you change modes.
This audio system can also play
CD-Rs and CD-RWs compressed in
MP3 or WMA formats. The numbers
of the folder and track playing are
shown in the display on the disc
player. A disc can support more than
99 folders, and each folder can hold
more than 255 playable files. A disc
can hold up to 999 files in total.
Video CDs and DVDs do not work in
this unit.
Depending on the software the files
were made with, it may not be
possible to play some files, or display
some text data.
Your vehicle’s in-dash disc changer
holds up to six discs.
If a file on a WMA disc is protected
by digital rights management
(DRM), the audio unit displays
UNSUPPORTED, and then skips to
the next file.
Press the LOAD button until you
hear a beep and see ‘‘LOAD’’ in
the display. To load only one disc,
press and release the LOAD
button.
The disc number for an empty
position begins blinking.
Insert the disc into the disc slot
when the green disc load indicator
comes on. Insert it only about
halfway; the drive will pull it in the
rest of the way. You will see
‘‘BUSY’’ in the display while the
disc load indicator turns red and
blinks as the disc is loaded.
153
1.
2.
3.
To Play a Disc
Playing Discs (Models without navigation system)
Loading Discs
152
NOTE:
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
10/08/27 14:34:23 31TP6610_157
2011 Accord Crosstour