Frequently asked questions, Navigation system manual – HONDA 2013 Pilot Navigation User Manual
Page 146
146 Navigation System
Frequently Asked Questions
Map and Features, Voice Operation, Entering Addresses
Problem
Solution
Why does the
Disclaimer
screen need to be displayed every
time I start the car? I am the only driver.
The
Disclaimer
screen reminds you and your guest drivers to always
operate the navigation system in a safe manner.
I tried entering an address, but the city or street could not be
found. Is there any other way to route to the location?
Some cities are lumped in with a major metro area. Try entering the street
first. In rural “unverified” areas or new subdivisions, streets may be
missing, or only partially numbered. Try selecting the destination directly
from the map. See By Map Input on
.
When I enter an address, some letters become grayed out. Is
this normal?
Yes. As you enter each letter in an address or a point of interest (POI), the
system looks in the database to see what letters are possible and “grays out”
letters that do not apply.
How do I delete Personal Addresses, Previous Destinations,
or the Home Address?
This is done in the
SETUP
screen (
Main Setup
), under “Personal
Information.” See
I cannot hear the navigation system voice.
1) Ensure that Volume in the
SETUP
screen (
Main Setup
) is not OFF.
2) Go to “Basic Settings” in the
SETUP
screen (
Other
), and set Voice
Recognition Tutor to ON. See
.
The voice control system is having difficulty recognizing my
voice commands.
Ensure that the vents are not blowing on the microphone on the ceiling, the
vehicle is as quiet as possible, and you are using the correct command when
speaking (see Improving Voice Recognition on
). Say “Help” at any
screen to see a list of the applicable voice commands. If the system cannot
recognize your command because of background noise, speak louder.
When the system pronounces the street name in the guidance
command or reads the destination address, it sounds strange.
What causes this?
The basic guidance phrase uses a studio-recorded voice, but the street name
is pronounced by the system using a machine-generated voice.
Consequently, the name may be mispronounced or sound strange at times.
When I drive at night, the screen is bright and will not switch
to the night display mode. Why?
Verify the following: The nighttime dash brightness control is not set to
maximum, and Map Color in SETUP is set to Black for Night. See
Switching Display Mode Manually on
2013 Pilot
Navigation System Manual
Intro
Index
Home
SEC
Frequently Asked Questions