HONDA 2012 Accord Navigation - Manual (Page 42)

42 Navigation System
Accord 2D4D_KA 31TA5840
Entering a Destination
Showing the Map of State
With the State selection, the display
changes to the
Select a state screen.
After you select the desired state, the
display changes to a map of the state,
with the crosshairs located near the
middle.
The yellow box indicates the area you
will see when you click on the current
map with the Interface Dial. The scale
will decrease each time you push in on
the Interface Dial, until
Select a
destination appears at the top of the
screen.
Use the Interface Dial to move the
crosshairs to the area of the state close
to your intended destination. If desired,
rotate the Interface Dial knob to
change the map scale. When you have
the crosshairs in the desired area, push
in on the Interface Dial. The address
of the location you have selected will
appear at the top of the screen.
NOTE:
The selected icon or road segment is
displayed on the 1/2 mile (800 meter) or
less map scale.
If this is the desired address, push in on
the Interface Dial again. If not, use the
Interface Dial to reposition the
crosshairs, then push in on the
Interface Dial again to display the new
address.
If you selected a single icon or road
segment, select Set as Dest. to
calculate a route to the selected
destination. If you selected multiple
icons within the cursor radius, select an
item from the list. Then select OK to
calculate a route to the selected
destination.
00_Accord 2D4D_KA.book 42 ページ ２０１１年７月２１日 木曜日 午後１時５９分
Intro
Index
Home
SEC
Entering a Destination
2012 Accord