HONDA 2011 Element - Manual (Page 209)

5. Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure one of the three arrows
on the rubber seal is facing up; it is
marked
‘‘ ’’.
7. Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
8. (Driver's side)
Install the front end of the air
intake duct.
Replacing a Daytime Running
Light Bulb
1. Open the hood.
2. Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
3. Remove the bulb by turning it one-
quarter turn counterclockwise.
4. Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
5. Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
6. Test the lights to make sure the
new bulb is working.
TAB
CONTINUED
Lights
203
Maintenance
10/08/06 08:34:41 11 ELEMENT MMC North America Owner's Man 50 31SCV680 enu