JVC KV-PX501 - Manual (Page 14)

14
Operating Methods
Startup
1. For first time use, please turn the system power
switch at the rear side On.
2. Press and hold the power button for about two seconds to turn on the power.
Note: Before the first time use, please switch the system power on.
System Reset
Only under extremely few circumstances will it be required to reboot the system.
Reset your system if the following situations occur:
1. Heavy lag experienced with screen refresh or operations, resulting in an
inoperable system.
2. Cannot turn off the system with power button.
3. No response with selection on the screen.
If any of above occurs, turn the system power switch at the rear side Off and turn it
back On to reboot the system.
Shutdown
1. While power is on, press the power button to
turn off power.
2. If the unit will not be used for a long time, turn
the system power switch at the rear side Off.
Using Vehicle Bracket
The included in vehicle bracket set can be securely suctioned on the front
windshield, or using the adhesive plate, securing on top of the glove compartment.
This device will effectively secure the GPS unit in the vehicle. Follow the
procedures below to secure the bracket:
1. Follow the arrows and slide the unit into the in-vehicle bracket fitting holes to
secure.
2. Gently push down until the unit is tightly fixed with the bracket.
Note: Please note the directions of the
arrows, when fitted the assembly should
be tight. If these directions are not
followed, a loose fit will result, and
components must be reassembled.
Power
button
System
power
switch