Candy LS DFI 50 UK - Manual (Page 13)

25
Identifying minor faults
Warning!
Before removing any panel: 1. Turn the knob to STOP.
2. Pull the electric plug out.
Should the dishwasher fail to operate, before contacting the Service Centre, make the
following checks:
FAULT CAUSE REMEDY
1 - Machine completely dead
2 - Machine does not
draw water
3 - Machine does not
discharge water
4 - Machine discharges water
continuously
5 - Spray arms are not heard
to rotate
6 - On electronic appliances
without a display: “eco”indicator
light and indicator light “No.1”
with audible signal are heard.
7 - On electronic appliances with
a display: “E1” appears on the
display with audible signal.
Plug is not connected to wall
socket
O/I button has not been pressed
Door is open
No electricity
See causes for no. 1
Water tap is turned off
Programme selector is not at
correct position
The inlet hose is bent
The inlet hose filter is not
correctly connected
Filter is dirty
Outlet hose is kinked
The outlet hose extension is
not correctly connected
The outlet connection on the
wall is pointing downwards not
upwards
Position of outlet hose is too
low
Excessive amount of detergent
Item prevents arms from rotating
Plate and cup filter very dirty
Water inlet tap turned off
Water inlet tap turned off
Connect electric plug
Press button
Close door
Check the fuse in the plug and
the electricity supply
Check
Turn water tap on
Turn programme selector to
correct position
Eliminate the bends in the hose
Clean the filter at the end of the
hose
Clean filter
Straighten outlet hose
Follow the instructions for
connecting the outlet hose
carefully
Call a qualified technician
Lift outlet hose to at least 40 cm
above floor level
Reduce amount of detergent
Use suitable detergent
Check
Clean plate and cup filter
Switch off the appliance.
Turn on the tap.
Re-set the cycle.
Switch off the appliance.
Turn on the tap.
Re-set the cycle.
Selecting the programme and
special functions
Use in conjunction with programme guide
After loading the dishwasher and adding the
detergent, leave the door ajar so as to access the
controls.
Turn the “E” knob (on the right of the control
panel) clockwise to the programme N° required
(this will be shown in display “D”).
To start the machine press the button and
close the door.
In case of incorrect selection of programme,
rotate the “E” knob clockwise to the correct
required programme.
End of programme
When the programme knob is on the STOP
position the wash cycle has ended.
Open the door and switch off the appliance by
pressing the button before unloading the
dishwasher.
“65°C” button
This button is an option available on the
UNIVERSAL INTENSIVE 65°C and DAILY
INTENSIVE 65°C
programmes which will
increase the temperature of the water of washing
from 50°C to 65°C.
Warning
Attention
This dishwasher is equipped with an anti-overflow
safety device which works even when power is
switched off, and if the water level is too high the
supply will automatically be closed off.
Important
To ensure the correct operation of the
anti-overflow safety device, it is recommended
not to move or to tilt the dishwasher during
operation.
If it is necessary to move or to tilt the dishwasher,
first make sure the washing cycle is finished and
that no water is left in the tank.
1) It is not advisable to open the door while the
machine is in operation, particularly during the
middle stage of the wash programme and the
final hot rinse. Should anyone open the door
inadvertently, the machine will automatically
stop.
2) Before starting the new programme, make
sure that the detergent has not already been
released. If it has, then top up the dispenser.
3) At the end of the wash cycle it is advisable to
turn off the water supply and unplug the
machine from the mains.
24