VDO Z3 PC - Manual (Page 43)

34
EN
13.3. SETTING TIMER 1 + 2 REPEATS (when selecting timer 1 + 2)
3 sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ TIMER SETTINGS
‚ TIMER ?SELECT?
∂ TIMER 1 ?SELECT?
∂ ƒ TIMER 1 + 2 ?SELECT?
‚ TIMER 1+2 REPEATS ?SELECT?
∂ ƒ Setting the number of repeats (keep button de-
pressed for fast run-through)
‚ TIMER 1+2 ?SET OK?
‚ TIMER 1+2 SET DONE
Automatic return to the operation mode for TIMER 1/2. If you have not
yet set any values for timer 1, and/or timer 2, then your VDO computer
will now show ERROR in the display.
13.4 SETTING THE COUNTDOWN (when selecting countdown timer)
3 sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ TIMER SETTINGS
‚ TIMER ?SELECT?
∂ TIMER ?SET?
‚ TIMER 1 ?SET?
∂ COUNTDOWN ?SET?
‚ SET HOUR ?CONTINUE?
∂ ƒ Setting hours (keep button depressed for fast run-
through)
‚ SET MINUTES ?CONTINUE?
∂ ƒ Setting minutes (keep button depressed for fast run-
through)
‚ SET SECONDS ?CONTINUE?
∂ ƒ Setting seconds (keep button depressed for fast run-
through)
‚ COUNTDOWN ?SET OK?
‚ COUNTDOWN SET DONE
Automatic return to the operation mode for COUNTDOWN
If you have not yet set any values for countdown, then your VDO com-
puter will now show ERROR in the display.
13.5. LAP-TIMER
The LAP timer must first be started with the ∫ button. To save the LAP
data press buttons ≈ + ¥ at the same time on the desired points of
the training unit. In this process the following values will be saved:
- Duration of the lap
- Average heart rate on the lap
- Average speed on the lap
The lap values can be called at any time if time measurement is
stopped.
13.6. STOPWATCH
Use of the stopwatch does not require any previous setting. After
preselect (see chapter 13.1), it can be stopped or started at any time
with ∫ .