Candy DSI 785 X PLAN - Manual (Page 9)

17
Attention
This dishwasher is equipped with an anti-overflow safety device
which works even when power is switched off, and if the water
level is too high the supply will automatically be closed off.
Important
To ensure the correct operation of the anti-overflow safety
device, it is recommended not to move or to tilt the dishwasher
during operation.
If it is necessary to move or to tilt the dishwasher, first make
sure the washing cycle is finished and that no water is left in
the tank.
To set the programme, turn the dial clockwise until the pointer
(
● ) indicates the symbol of the required programme on the
control panel. Then press the On/Off button. Ensure that the
water supply is turned on and the door is closed properly.
“70°C” button
This button is an option available on the UNIVERSAL
INTENSIVE 70°C and DAILY INTENSIVE 70°C programmes
which will increase the temperature of the water of washing
from 50°C to 70°C.
Extra rinse button
Extra rinse for very dirty washing.
Half load button
By pressing this button it is possible to wash a small quantity
of crockery using only the upper basket for dishes and cutlery
in the bottom basket. This reduces water and energy
consumption and requires a smaller quantity of detergent as well.
Start Delay Control
Start Delay is available on all programmes and is used to
postpone the start of programmes by up to 12 hours. Each one
hour period is marked. If you wish to delay the start, simply
load the machine, load the dispenser with detergent, and turn
the programme control knob clockwise to the number of hours
you wish the programme to be delayed. For example if it is
8pm and you want the machine to start at midnight, turn the
start delay knob to 4. Press the On/Off button. The red pilot
light will come on to show that the machine is switched on. The
start of the programme will then be delayed according to the
selected time.
The cycle ends
When the program handle reaches the
S symbol, the cycle ends.
Push the On/Off button to cut power to the dishwasher and
then only open the door.
Selecting the programme and special functions
Use in conjunction with programme guide
16
The water-stop device protects against water damages caused by
leaks on the fill hose which could develop due to natural ageing
of the hose.
In the water-stop system the leaking water fills the corrugated
hose and activates a stop valve which cuts off the water supply to
the machine.
This fault is shown by a red sector on the window «A».
Would this occur, please refer to your Service Agent.
If the hose is not long enough for correct connection, it must be
replaced with a longer one. The hose can be obtained from your
Service Agent.
Watercontrol-system
Red button blocked
valve indicator
Safety antitwist device
(press and twist to
remove the washer)
A