Candy EVO 1683DW-80 - Manual (Page 5)

“START/PAUSE” button
Press to start the selected cycle .
Changing the settings after the programmes has started (PAUSE)
Press and hold the “START/PAUSE” button for about 2 seconds, the flashing lights on the
options buttons and time remaining indicator will show that the machine has been paused,
adjust as required and press the “START/PAUSE” button again to cancel the flashing lights.
If you wish to add or remove items during washing, wait 2 minutes until the safety device
unlocks the door.
When you have carried out the manoeuvre, close the door, press "Start/Pause" button and
the appliance will continue working where it left off.
CANCELLING THE PROGRAMME
To cancel the programme, set the selector to the OFF position.
Select a different programme.
Re-set the programme selector to the OFF position.
9
D
The option buttons should be selected before pressing
the "Start/Pause" button.
“TEMPERATURE SELECTION” button
When a programme is selected the relevant indicator will light up to show the recommended
wash temperature. The Temperature button can be used to decrease or increase the
temperature of your chosen wash cycle. Each time the button is pressed, the new
temperature level is shown on the Wash Temperature Indicator.
E
Door handle
To open the door turn the handle as shown in the picture.
A special safety device prevents the door from being opened
immediately after the end of the cycle.
Wait for 2 minutes after the wash cycle has finished and the “Door
Security
” light has gone out before opening the door. At the end of
the cycle turn the programme selector to "OFF" .
A
8
DOOR SECURITY indicator light
The “Door Security” indicator light is illuminated when the door is fully closed and the machine is ON.
When "Start/Pause" is pressed on the machine with the door closed the indicator will flash
momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
A special safety device prevents the door from being opened immediately after the end of the cycle.
Wait for 2 minutes after the wash cycle has finished and the “Door Security” light has gone out
before opening the door. At the end of the cycle turn the programme selector to "OFF" .
B
NOTE:
Few seconds after the start the wash cycle will begin. During the first 4
minutes of the wash cycle, the kg detector (active only on cotton and
synthetics programmes) will weigh the clothes and update the maximum
wash time remaining on the display every five seconds until the weight
has been determined.
While this function is operating the “kg detector” indicator is on.
C
“FAST IRON” button
The Fast Iron function (Not available on COTTON programmes) minimizes creases as much
as possible with a uniquely designed anti-crease system that is tailored to specific fabrics.
MIXED FABRICS - the water is gradually cooled throughout the final two rinses with no
spinning and then a delicate spin assures the maximum relaxation of the fabrics.
DELICATE FABRICS – after the final two rinses with no spinning the machine stops in the
final rinse stage and the option indicators blink. The load is held in the water in the drum,
thus reducing creasing and enabling easier ironing.
WOLLENS/HAND WASH – after the final rinse the load is held in the water in the drum,
thus reducing creasing and enabling easier ironing and the option indicators blink.
To complete the cycle press the Fast Iron button and the machine will pump out the water
and complete the cycle.
If you do not want to spin the clothes and activate drain only:
- Turn the programme selector to the "OFF" position;
- Select programme drain only ;
- Switch on the appliance again by pressing the "Start/Pause" button.