Candy LB CN 120 T UK - Manual (Page 13)

Note: it is advisable to turn off the tap after each wash
to isolate the washing machine from the water supply.
For the washing machine to function properly the terminal end of the discharge hose (mouth)
must be at a minimum of 50 cm and a maximum of 85 cm from the ground.
ELECTRICAL CONNECTIONS
After installation, the appliance must be positioned so that the plug is accessible.
If the plug we supply does not fit
CUT IT OFF AND DESTROY IT!
You can’t use it on other appliances, and the exposed wires could be dangerous if plugged in.
To fit a replacement plug, proceed as follows:
Connect to the terminal in the plug
green and yellow wire marked with the letter E,
OR marked
with the symbol,
OR coloured green,
OR coloured green and yellow.
blue wire marked N
OR coloured black.
brown wire marked L
OR coloured red.
WARNING
This appliance must be earthed
Fuses and plugs
This appliance should be used only on a socket with a minimum rating of 13 Amp.
Our ready-fitted plug is already equipped with a 13 amp fuse which is BS 1362 ASTA
approved. Any replacement should be exactly the same.
If the fuse cover is lost, do not use the plug until it is replaced. A correct replacement fuse
cover (obtainable from your local retailer) must be the same colour as shown or named on
the insert on the base of the plug.
Note: we recommend you keep the transit bracket, braces
and screws to immobilise the machine for future transit.
The Manufacturers will not be responsible for any possible
damage to the machine caused by not following the rules
relating to releasing the mechanism. The user is
responsible for all costs of installation.
Water connection
The appliance must be connected to the water mains using new
hose-sets.
The old hose-sets should not be reused.
Your machine may either be plumbed in or connected to existing
taps, using a tap adaptor with a 3/4 B.S.P. threaded end
connection. The water supply hoses to be found inside the drum
are terminated in two different ways. One end which has a 90°
elbow is to be connected to the appliance water connection E
while the straight end is to be connected to the domestic supply
tap. The hose with the white collar should be connected to the
cold tap, and the hose with the red collar to the hot tap. The
appliance is not suitable for use with mixer taps.
Cold Water Supply
If you have no hot water supply or your hot
water pressure is low:
A cold fill adapter , allowing the installation of the
machine with a cold water supply only can be
purchased from Gias Service
(Tel. No. 01204 556111).
min 50 cm
max 85 cm
+2,6 mt max
max 100 cm
min 4 cm
E
HOT
WATER
COLD
WATER
24 25