Candy GO W485D-UK - Manual (Page 17)

17
M START BUTTON
Press to start the selected cycle.
NOTE:
FEW SECONDS AFTER THE START THE WASH CYCLE WILL
BEGIN. DURING THE FIRST 4 MINUTES OF THE WASH
CYCLE, THE KG DETECTOR (ACTIVE ONLY ON COTTON
AND SYNTHETICS PROGRAMMES) WILL WEIGH THE
CLOTHES AND UPDATE THE MAXIMUM WASH TIME
REMAINING ON THE DISPLAY EVERY FIVE SECONDS
UNTIL THE WEIGHT HAS BEEN DETERMINED.
WHILE THIS FUNCTION IS OPERATING THE “Kg
DETECTOR” INDICATOR IS ON.
CHANGING THE SETTINGS AFTER THE PROGRAMMES HAS STARTED
(PAUSE)
Press and hold the “START/PAUSE” button for about 2 seconds,
the flashing lights on the options buttons and time remaining
indicator will show that the machine has been paused, adjust
as required and press the “START/PAUSE” button again to
cancel the flashing lights.
If you wish to add or remove items during washing, wait 2
minutes until the safety device unlocks the door.
When you have carried out the manoeuvre, close the door,
press START button and the appliance will continue working
where it left off.
CANCELLING THE PROGRAMME
To cancel the programme, set the selector to the OFF position.
Select a different programme.
Re-set the programme selector to the OFF position.
DOOR LOCKED INDICATOR
The “Door Locked” indicator light is illuminated when the door is
fully closed and the machine is ON.
When START is pressed on the machine with the door closed the
indicator will flash momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
A special safety device prevents the door from being opened
immediately after the end of the cycle. Wait for 2 minutes after
the wash cycle has finished and the Door Locked light has
gone out before opening the door. At the end of cycle turn the
programme selector to OFF .
EN
N