Candy GO 106DF__L1-S User Manual
Page 9
17
EN
SPIN SPEED BUTTON
The spin cycle is very
important to remove as
much water as possible from
the laundry without
damaging the fabrics. You
can adjust the spin speed of
the machine to suit your
needs.
By pressing this button, it is
possible to reduce the
maximum speed, and if you
wish, the spin cycle can be
cancelled.
To reactivate the spin cycle
is enough to press the
button until you reach the
spin speed you would like to
set.
For not damage the fabrics,
it is not possible to increase
the speed over that
automatically suitable
during the selection of the
program.
It is possible to modify the
spin speed in any moment,
also without to pause the
machine.
NOTE:
THE MACHINE IS FITTED
WITH A SPECIAL
ELECTRONIC DEVICE,
WHICH PREVENTS THE
SPIN CYCLE SHOULD THE
LOAD BE UNBALANCED.
THIS REDUCES THE NOISE
AND VIBRATION IN THE
MACHINE AND SO
PROLONGS THE LIFE OF
YOUR MACHINE.
G
EL
K
K
.
.
.
.
.
HMEI
H:
H Y KEYH EINAI
E O
I MENH ME EI IKO
H EKTPONIKO AI
HTHPIO
OY A OTPE EI THN
EKTE E H TOY KYK OY
TI IMATO AN TA POYXA
TO TYM ANO EN EINAI
OMOIOMOP A
KATANEMHMENA. AYTO
A OTPE EI TO OPYBO KAI
TI ONH EI KAI
E A
A IZEI ME A YTEPH
IAPKEIA Z H TH
Y KEYH .
COLD WASH BUTTON
By pressing this button it is
possible to transform every
programme into a cold
washing one, without
modifying other
characteristics (water level,
times, rythmes, etc...).
Curtains, small carpets, man
made delicate fabrics, non
coulor fast garments can be
safely washed thanks to this
new device.
“DELAY START” BUTTON
This button allows you to pre-
programme the wash cycle
to delay the start of the
cycle for up to 24 hours.
To delay the start use the
following procedure:
Set the required programme.
Press the button once to
activate it (h00 appears on
the display) and then press it
again to set a 1 hour delay
(h01 appears on the display);
the pre-set delay increases
by 1 hour each time the
button is pressed, until h24
appears on the display, at
which point pressing the
button again will reset the
delay start to zero.
Confirm by pressing the
“START/PAUSE” button (the
light on the display starts to
flash). The countdown will
begin and when it has
finished the programme will
start automatically.
It is possible to cancel the
delay start by taking the
following action:
Press and hold the button for
5 seconds until the display
will show the settings for the
programme selected.
At this stage it is possible to
start the programme
previously selected by
pressing the “START/PAUSE”
button or to cancel the
process by setting the
selector to the OFF position
and then selecting another
programme.
16
EN
E
F
EL
,
,
(
,
v
,
, . . .).
,
,
,
,
,
.
K
KK
24
.
:
.
(
h00
)
1
(
h01
).
1
,
h24,
.
"START/PAUSE" (
).
.
:
5
,
.
,
"START/PAUSE",
OFF
.