Candy EVO4 1072D-S - Manual (Page 8)

15 14
C START BUTTON
Press to start the selected
cycle.
NOTE: WHEN THE START
BUTTON HAS BEEN
PRESSED, THE APPLIANCE
CAN TAKE FEW SECONDS
BEFORE STARTS
WORKING.
CHANGING THE SETTINGS
AFTER THE PROGRAMMES
HAS STARTED (PAUSE)
Press and hold the
“START/PAUSE” button for
about 2 seconds, the
flashing lights on the options
buttons and time remaining
indicator will show that the
machine has been paused,
adjust as required and press
the “START/PAUSE” button
again to cancel the flashing
lights.
If you wish to add or remove
items during washing, wait 2
minutes until the safety
device unlocks the door.
When you have carried out
the manoeuvre, close the
door, press START button and
the appliance will continue
working where it left off.
CANCELLING THE
PROGRAMME
To cancel the programme,
set the selector to the OFF
position.
Select a different
programme.
Re-set the programme
selector to the OFF position.
PROGRAMME START LIGHT
This lights up when the START
button has been pressed.
EN
D
RO
BUTON PORNIT/OPRIT
Apasand Start ca sa incepeti
un program de spalare.
ATENTIE: CAND ATI
APASAT BUTONUL
START, POT TRECE
CATEVA SECUNDE
INAINTE CA APARATUL
SA PORNEASCA.
A. SCHIMBAREA SETARILOR
DUPA CE PROGRAMUL A
INCEPUT (PAUSE)
Apasati si mentineti apasat
butonul “START/PAUSE”
(start/pauza) timp de
aproximativ 2 secunde,
indicatoarele de pe
butoanele cu optiuni si
indicatorul pentru timpul
ramas vor indica faptul ca
aparatul a fost trecut in
modul pauza, ajustati
functiile dorite apoi apasati
din nou butonul
“START/PAUSE” pentru a
intrerupe clipirea
indicatoarelor.
Daca doriti sa adaugati sau
sa scoateti obiecte in timpul
spalarii, asteptati 2 minute
pana cand dispozitivul de
siguranta deblocheaza usa.
Dupa ce ati facut manevra,
inchideti usa si apasati
butonul Start. Masina va
continua programul de unde
s-a oprit.
OPRIREA UNUI PROGRAM
Pentru a anula un program,
setati butonul selector pe
pozitia OFF (oprit).
Selectati un alt program.
Resetati butonul selector pe
pozitia OFF.
INDICATOR PORNIRE
PROGRAM
Acest indicator se aprinde
atunci cand este apasat
butonul START.
F
EN
BUTTONS INDICATOR LIGHT
These light up when the
relevant buttons are pressed.
If an option is selected that is
not compatible with the
selected programme then
the light on the button first
flashes and then goes off.
The option buttons should be
selected before pressing the
START button
“AQUAPLUS” BUTTON
By pressing this button you
can activate a special new
wash cycle in the Colourfast
and Mixed Fabrics programs,
thanks to the new Sensor
System. This option treats with
care the fibres of garments
and the delicate skin of those
who wear them.
The load is washed in a much
larger quantity of water and
this, together with the new
combined action of the drum
rotation cycles, where water is
filled and emptied, will give
you garments which have
been cleaned and rinsed to
perfection. The amount of
water in the wash is increased
so that the detergent
dissolves perfectly, ensuring an
efficient cleaning action. The
amount of water is also
increased during the rinse
procedure so as to remove all
traces of detergent from the
fibres.
This function has been
specifically designed for
people with delicate and
sensitive skin, for whom even a
very small amount of
detergent can cause irritation
or allergy.
You are advised to also use
this function for children’s
clothing and for delicate
fabrics in general, or when
washing garments made of
towelling, where the fibres
tend to absorb a greater
quantity of detergent. To
ensure the best performance
for your wash, this function is
always activated on the
Delicates and
Woollens/Handwash
programs.
E
RO
LED INDICATOR BUTOANE
Aceste indicatoare se
aprind atunci cand sunt
apasate butoanele
corespunzatoare.
Daca este selectata o
optiune care nu este
compatibila cu programul
selectat, atunci indicatorul
de pe buton va clipi apoi se
va stinge.
ATENTIE!
Butoanele optionale trebuie
selectate inainte de a apasa
butonul START.
BUTON “AQUAPLUS”
Apasand acest buton se
activeaza un ciclu special
de spalare, nou pentru
gama tesaturile mixte si cu
culori sensibile, datorita
noului sistem "Sensor System".
Rufele sunt spalate intr-o
cantitate mai mare de apa
si aceasta, impreuna cu
actiunea combinata a
rotatiilor tamburului, ce
umple si scoate apa, va
face caq rufele sa fie
spalate si clatite foarte bine.
Cantitatea sporita de apa
ce este folosita in timpul
spalarii canduce la o
dizolvare mai buna a
detergentului. Cantitatea de
apa este de asemenea
marita si in timpul procesului
de clatire eliminand astfel
orice urma de detergent de
pe fibre. Acesta functie a
fost dezvoltata pentru cei
care au pielea foarte
sensibila si pentru care o
urma fina de detergent pe
haine le poate provoca
iritatii sau alergii. Ca sfat, este
bine sa folositi aceasta
functie cand spalati rufe
pentru copii si pentru rufe
delicate, sau pentru
materiale asemanatoare
celor de la prosoape, care
tind sa absoarba o cantitate
mare de detergent. Pentru a
asigura o buna spalare,
aceasta functie e
intotdeauna activata in
cadrul programelor pentru
spalarea tesaturilor delicate
si a lanei/spalat cu mana.