Candy CFD 2760 E - Manual (Page 4)

NB . T his is the rating plate. If you need to contact our S ervice Department in the event of faults , remember to give them the
information on the plate.
Important: If the room temperature is very warm, the appliance may work continuous ly and a layer of fros t
will depos it on the back of the fridge compartment. In this cas e, turn the knob to lower s ettings (1-2).
DOUB L E DOOR
C ONT R OL PA NE L
T he thermostat box to control the appliance
is located inside the fridge compartment on
the top right. To check whether the appliance
is functioning, make sure that the thermostat
knob is not set on Œ
0•.
DE F R OS T ING and F R E E ZING
T he rating plate states the maximum quantity of foods that can be frozen, (see “ gure 2).
Freezing is guaranteed with any knob setting.
(F igure 2)
Defrosting of the fridge compartment occurs automatically
in this product.
We recommend you defrost the freezer area when the
layer of frost is more than 3 mm thick.
A small amount of frost or drops of water on the back
of the fridge compartment when the fridge is working is
normal
Ma ke s ure the wa ter outlet is a lways clea n. Ma ke
sure foods do not touch the back or sides of the fridge
compartment
R E V E R S ING T HE OP E NING OF T HE DOOR S
In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.
P lace or tilt the fridge at a 45° angle, since
it is necessary to work on the bottom of the
appliance
1
R emove the middle screw and remove the top
door
3
R emove the bottom hinge by removing the
screws, the plug and washers, then remove the
bottom door
2
A
3 E N
Wait at least two hours before switching the appliance on, in order to ensure that the refrigerant circuit is fully efficient.