Philips HB823 - Manual (Page 7)

Environment
Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for
recycling. By doing this you will help to preserve the environment (Fig. 22).
The lamps of the appliance contain substances that can be harmful to the environment. When you discard the lamps, do not throw them away
with the normal household waste but hand them in at an official collection point.
guarantee & service
If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer
Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your
country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.
guarantee restrictions
The tanning lamps are not covered by the terms of the international guarantee.
troubleshooting
The appliance may fail to work properly because it has not been installed or is not used in accordance with the instructions. In that case you are
able to solve the problem yourself by following the troubleshooting tips below.
Problem Solution
The appliance does not start The lamp unit has not been put in the right position (see chapter ‘Preparing for use’.
The plug has not been properly inserted into the wall socket.
Perhaps there is a power failure. Check by means of another appliance.
The lamps are still too hot to go on. Let them cool down for 3 minutes first.
The appliance was not sufficiently cooled and the overheating protection switched the appliance
off automatically. Remove the cause of overheating (e.g. remove a towel that is blocking one or
more vents). Wait for 10 minutes and switch the appliance back on.
The fuse cuts off the power when you
switch on the tanning appliance or during
use.
Check the fuse of the circuit to which the tanning appliance is connected. The correct fuse type
is a 16A standard fuse or a slow-blow automatic fuse. The fuse may also blow because you have
connected too many appliances to the same circuit.
Poor tanning results You are not following the tanning schedule suitable for your skin type. Check the table in ‘Tanning
sessions: how often and how long?’.
The distance between the lamps and the surface you lie on is larger than prescribed.
When the lamps have been used for a long time, the UV light emitted will decrease. This effect
only becomes noticeable after several years. You can solve this problem by selecting a longer
tanning time or by having the lamps replaced.
,
EngliSH 7