Candy CDI 1012__янв.80 - Manual (Page 5)

■ Fasten the two supplied frames with 4 of
the 4 x 16 mm diameter screws, setting
them at the center of the eyelets (fig. 6).
■ Hang the panel on the dishwasher door
and align it by adjusting the frames with
the eyelets.
■ Fix the frames with the other 6 screws
4x16 mm in the specif holes (fig. 6).
■ Fasten the panel to the dishwasher door
with the screws 3.5 x 13 mm (fig. 7).
N.B.:
If you wish to fit a wooden panel with
false drawer, ask for special kit to the
Assistance Service.
Wooden panel installation
This dishwasher model is equipped with an
auto-balancing system in the door and
comes ready to mount a wooden panel of
the following size:
Width 596,5 mm max
Height from 645 to 715 mm max
Thickness from 18 to 22 mm max
This allows the use of a regular wing taken
from a drawer furniture weighing from 3 to
7 kg; for coverings weighing more, ask for
information to the Assistance Service.
Drilling arrangements
■ Drill 12 mm deep holes in the panel
using a 2 mm diameter drill according to
the measures indicated in the figure 5.
715 max.
645 min.
350
178
596,5 max.
= = 572
6
7
5
9
2
8
TECHNICAL NOTES FOR
CABINET FITTERS
This dishwasher model can be embedded
in modular furniture, under a counter top, a
continuous counter top or a sink.
■ The housing dimensions must be the
same as those indicated in the figure 1.
■ The adjustable feet allow the height of
the machine to be varied from 820 to
885 mm.
Installation under the counter top
■ Adjust the dishwasher height to adapt it
to the housing “A” dimensions, level it
by means of the adjustable feet, which
will then be blocked with the lock-nut (fig.
2-3).
■ Insert the dishwasher in the housing and
connect the dishwasher to water and
power following the instruction booklet;
if necessary, re-adjust the front and rear
feet and block them again with the
lock-nut.
■ Fasten the dishwasher with the supplied
16 mm long screws “A”, as indicated in
the figure 4.
600
570
550
550 597
100
40
820+(65)
100 170
+(65) 820+(65)
160
598
1
3
4