Candy CFBC 3290 A - Manual (Page 10)

ALIGNING UNIT DOORS WITH THE
FRIDGE-FREEZER DOORS
ENSURING YOUR FRIDGE-FREEZER
WORKS PROPERLY
After fi tting the appliance, place the rear of the unit against the wall to
prevent access to the compressor unit.
To make sure the fridge-freezer works properly, air must circulate to cool
the condenser which is situated at the bottom of the appliance.
The unit must have a rear outlet with top opening that is not obstructed
and a front opening which is covered by the ventilation grid. The appliance is supplied with fi ttings (slides and slide brackets) to
align the fridge-freezer doors with the doors of the unit.
Open the doors of the unit and fridge. Position the slide bracket
around the slide and secure to the appliance door.
Mark the holes for the screws and drill with a 2.5 mm diameter bit.
Fit the appliance door to the door of the unit, using the slots on the
slide bracket as a guide.
Size of the unit cut outs.
Room to leave between the unit and ceiling.
8 EN
540x50mm
540x50mm
380x37mm
380x50mm
58
0
50mm
Fix the slide on the inside of the unit door, at the height you want.
Make sure it is approximately 20 mm from the outside edge of the
door.
20