Acclaim Lighting AL Dimmer 3F HP - Manual (Page 2)

-2-
The following contents instruct to how to make the selection for the output current as 350mA or 700mA.
1. Take out the AL-DIMMER-3F HP and the screw driver from packing.
2. Use the screw driver to prize up the rear panel of AL-DIMMER-3F HP with the proper stength, as the following
figures.
3. Use the screw driver to move the 2 way dip-switch to on or off for output current option.
4. After the current was selected, to reassemble the rear panel.
2 way dip-switch
2 = on
1 = on
Output current = 700mA
2 = off
1 = off
Output current = 350mA
ON
OFF 1 2
After the reassembly is completed, your AL-DIMMER-3F HP is ready to use.
Reassembly
Make sure the output current matches the power requirements of the LED fixtures prior to use AL-DIMMER-3F HP.
2.Output Current Option
While the built-in Dipswitch is "On",t the AL-DIMMER-3F HP outputs
3 groups current of 700mA .
o link to the power, the LED indicator lights red,
The output current defaults as 350mA
While the built-in Dipswitch is "Off", the AL-DIMMER-3F HP
outputs 3 groups current of 350mA .
and a built-in Dipswitch allows the user to select the output current
as 350mA or 700mA.
to link to the power, the LED indicator is blacked out ,
OPERATION GUIDE
The AL-DIMMER-3F HP features the user may use the 3 faders to separately control the intensity of the 3 channels
(Red, Green & Blue).Also, the outputs intensity of these 3 channels can be controlled by Dipswitch, DMX or infrared
remote controller as well. At this time, the AL-DIMMER-3F HP will take the highest luminance value as the priority
outputs intensity.
1.Luminance