Remington S8670 - Manual (Page 4)

ENGLISH
2
TO CHANGE THE STRAIGHTENING/CRIMPING PLATES
• Ensure the unit is switched off and cool.
• Slide the plates out holding the plastic edges.
• Turn the plates over and slot back into place.
TO SECURE ATTACHMENT TO HANDLE
• Ensure the locking ring is in the unlocked position, ready to insert the attachment.
Locate the pins on the attachment and holes on the handle. (DIAGRAM 1)
• Firmly push together. (DIAGRAM 2)
• Turn the locking ring anti-clockwise to secure the handle and the attachment together,
while still pressing down on the attachment (DIAGRAM 3).
Plug in the unit and switch on, the first green LED indicator light will start flashing.
NOTE:The unit will not turn on unless the attachment is inserted correctly.
Select the desired temperature. To change the temperature, use the ‘+’ or ‘-’ buttons
to increase or decrease the temperature. The LED lights will flash until your desired
temperature has been reached. After use switch the unit off.
For finer hair types a lower temperature is recommended.
IMPORTANT INSTRUCTIONS
Due to the extreme heat capabilities of this styler, extra care should be taken when
using.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
CLEANING AND MAINTENANCE
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a
damp cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
SAFETY CAUTIONS
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION OF
A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.
100201_REM_IFU_S8670_21L.indd GB_2 100201_REM_IFU_S8670_21L.indd GB_2 30.03.10 21:50 30.03.10 21:50