Remington F4800 - Manual (Page 3)

4 5
ENGLISH ENGLISH
• Hold the shaving head so that the foils touch your face
• Use short, circular strokes.
, TRIMMING
• While your shaver is switched on, slide the on/off switch upwards to activate the
trimmer.
• Push the trimmer release button.
• Hold the trimmer at a right angle to your skin
• To retract the trimmer push the top rear of the trimmer downward until it locks under
the trimmer release button.
E Tips for best results
• Ensure your skin is dry. Always hold the shaver at right angles to the skin so that all three
heads are touching the skin with equal pressure.
• Use moderate to slow stroking movements. The use of short circular motions in stubborn
areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid damage to the foil.
C CARE FOR YOUR SHAVER
• Care for your appliance to ensure a long lasting performance.
• We recommend you clean your appliance after each use.
• The easiest and the most hygienic way to clean the appliance is by rinsing the appliance
head after use with warm water.
• Keep the trimmer in the “off” position when the shaver is not in use.
C DRY CLEANING
• Ensure the shaver is switched off and unplugged from the mains outlet.
• Pull the foil assembly up to remove from hair pocket.
• Thoroughly blow out the stubble from the foils and cutters.
• Tap out excess hair shavings and use a cleaning brush if necessary.
• Do not clean the shaving foil with a brush.
• Replace head assembly.
C WASHABLE CLEANING
• Ensure the shaver is switched off and unplugged from the mains outlet.
• Pull the foil assembly up to remove from hair pocket.
• Foils – do not use the brush to clean the foils. Instead, blow the shavings out or rinse the
foils under cold water or warm water.
• Cutters & Trimmers – Use the cleaning brush to sweep any loose hairs from the cutter
and trimmer. Rinse them in cold or warm water. Do not use hot water.
• After cleaning, replace the head assembly.
• Replace head assembly.
A CAUTION
Never submerge your shaver completely under water.
C TRIMMER
Lubricate the teeth of the trimmer every six months with one drop of sewing machine oil.
, REPLACING THE FOILS & CUTTERS
To ensure the continued highest quality performance from your shaver, we recommend that
foils and cutters are replaced regularly.
, SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shave may not feel as close and you may feel your cutter
pulling your hair.
Wear through: You may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Pull the foil assembly up to remove from the hair pocket.
• Insert new foil assembly in hair pocket until it snaps into place.
, TO REPLACE THE CUTTERS
• Grasp cutter between thumb and forefinger and pull forward.
• Snap both new cutter assemblies into top of oscillator tips.
Note: DO NOT press on the cutter ends as this may cause damage.
Rotary heads replacement model: SPF-200
F IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDICE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO
PERSONS:
• An appliance should never be left unattended when plugged in to a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Make sure the power plug and cord do not get wet.
• Do not plug or unplug the appliance with wet hands.
• Do not use the product with a damaged cord. A replacement can be obtained via our