Verbatim MediaShare Wireless - Manual (Page 4)

4
③ Wi-Fi LED
Blue LED shows the Wi-Fi connection state.
• Flashing indicates that initiation is in process.
• ON indicates Wi-Fi initiation has completed.
• The LED is OFF for the following situations:
— Device is on, but the Wi-Fi signal is weak.
— Device is off.
— Device is in Mobile Mode but the Wi-Fi is off.
④ WAN LED
• Green: Connected to WAN via the bridge.
• Off: Not connected to the Internet.
⑤ USB Host Port
Insert a USB flash drive or USB hard drive for Wi-Fi access.
⑥ Reset Button
Reset the device to Factory Default configuration. Use a straightened paper clip or
pin to activate the switch. Any changes made to system settings such as passwords,
SSID, bridged Wireless LAN settings will be lost
⑦ SD Card Slot
Insert SD card for Wi-Fi access. Insert microSD card using appropriate adapter.
⑧ USB Device Port
Use the included USB cable to connect to a computer over USB 2.0. Then you can
transmit data and charge the device.
⑨ Power Button
Turns the device on/off.
1. Charge your MediaShare™ Wireless. Connect your MediaShare™ Wireless
micro USB port (8)via the supplied micro USB cable to a USB port of a computer
or USB power supply. When your MediaShare™ Wireless is fully charged the
Green Led (1) will stop flashing.
2. Insert an SD card or connect a USB drive (flash or HDD) to the USB host port.
3. Search for the “MediaShare™ Wireless” app from your portable devices app
store, then download and install to your device.
4. Power on your MediaShare™ Wireless by pressing on/off button. Blue Wi-Fi led
(2) will flash until wireless broadcasting is established.
diaShare Wireless QSG 15langs 100x140mm.indd 4 26/04/2013 14:3