Verbatim Multimedia Audio Bar 2.1 Speaker System - Manual (Page 3)

4 5
6. 3.5mm Microphone Cable (Red)
7. AUX IN: 3.5mm Stereo Input Jack
8. DC IN Jack
Power Setup
AC Power
Connect AC Adaptor power cord into the “DC In” jack on back of speaker, plug the
AC Adaptor into a power outlet.
Connections
1. Line In: Connect the attached 3.5mm Stereo Audio Cable (Green) into the “Line
In/Headphone” jack on your audio source, such as your PC or Laptop iPod, MP3
player, CD player, PC and etc.
2. AUX In: Alternatively connect the 3.5mm Stereo Input Cable into the “AUX IN”
jack on back of speaker and connect the other end to your audio source i.e. MP3
player, CD player
3. Microphone: To use Microphone with your audio source, e.g. PC or Laptop,
connect the attached 3.5mm Stereo Microphone Cable (Red) into the
“Microphone” jack on your audio source. The built-in microphone is located on the
front panel of speaker.
4. Headphone: To use a stereo headphone for private listening, connect the cable
from your headphones to the “ ” jack on side of speaker.
5. Power & Volume Control: Turn the knob clockwise to power on the speaker and
adjust to desired volume.
System Specifi cations
- Total 8 Watts RMS
- Satellites: 2” x (30 x 70mm) 4Ω Drivers
- Woofer : 2” 8Ω Drivers
- Pre-amplifi ed & Magneticall Shielded
- Power LED, Power & Volume Control
- Built-in Microphone
- Signal Input : AUX IN (3.5mm Stereo Input) Jack, 3.5mm Stereo Audio Cable
(Green), 3.5mm Stereo Headphone Jack
- 3.5mm Microphone Cable (Red)
- Dimensions: W370 x H76.5 x D63mm
Technical Support
For technical support please contact the following:
Europe: For technical support in Europe e-mail [email protected]