Acnodes FES 2217 - Manual (Page 2)

Copyright
This publication contains information that is protected by copyright. No part of it may be reproduced in
any form or by any means or used to make any transformation/adaptation without the prior written
permission from the copyright holders. The manufacturer reserves the right to revise this publication and
make changes to its contents at any time, without obligation to notify any person or entity of such
revisions or changes.
©2013. All Rights Reserved.
Trademarks
All trademarks and registered trademarks of products appearing in this manual are the properties of their
respective holders.
Notice:
1. The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
2. Shielded interface cables must be used in order to comply with the emission limits.
Static Electricity Precautions
It is quite easy to inadvertently damage the system board, components or devices even before installing
them in your system unit. Static electrical discharge can damage computer components without causing
any signs of physical damage. You must take extra care in handling them to ensure against electrostatic
build up.
1. To prevent electrostatic build up, leave the system board in its anti-static bag until you are ready to install
it.
2. Wear an antistatic wrist strap.
3. Do all preparation work on a static-free surface.
4. Hold the device only by its edges. Be careful not to touch any of the components, contacts or
connections.
5. Avoid touching the pins or contacting all modules and connectors. Hold modules or connectors by their
ends.
Important:
Electrostatic discharge (ESD) can damage your processor, disk drive and other components. Perform the upgrade instruction
procedures described at an ESD workstation only. If such a station is not available, you can provide some ESD protection by
wearing an antistatic wrist strap and attaching it to a metal part of the system chassis. If a wrist strap is unavailable, establish
and maintain contact with the system chassis throughout any procedures requiring ESD protection.