Acoustic Research ARHT10 - Manual

CAUTION!
DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire
extension cords or adapters. This surge protector is designed for indoor use
only. Install the surge protector away from heat emitting appliances such
as radiators or heat registers. DO NOT install where excessive moisture
is present. DO NOT plug extension cords into the surge protector. Never
install electrical or telephone wiring during a lightning storm. DO NOT
USE FOR MEDICAL OR OTHER LIFE SUPPORT EQUIPMENT OR
OTHER HIGH RISK ACTIVITIES. DO NOT USE IN DAMP AREAS OR
NEAR WATER RELATED APPLICATIONS SUCH AS AQUARIUMS, HOT
TUBS, ETC.
1. Plug the surge protector into a grounded 3-prong outlet only.
2. Plug all connected equipment directly into the surge protector.
3. Press the master power switch to turn on the surge protector.
ARHT10 User’s Guide
Connecting Equipment To Your
AR Surge Protector
Power Connections
RECEIVER
TV
VCR
DVD
AUDIO EQUIPMENT
MASTER
POWER SWITCH
GROUNDED
OUTLET
The 2.1 USB Charge outlet on this charger is optimized for use
with certain types of devices such as the iPad
® . As a result, the
2.1 USB Charge outlet may not charge all models of all brands of
your mobile devices. If any of your devices will not charge using
the 2.1 USB Charge outlet on this charger, use the other USB
Charge outlet to charge that device.
This surge protector is designed to charge two devices
simultaneously. However, if you plug in two devices to charge
simultaneously and their combined power requirements exceed
the power capacity of this surge protector, this surge protector
will shut down to protect your devices. In that case, try charging
each device by itself.
USB Charging
USB device USB cable
USB device USB cable
Indicator Lights
• The Protected light should be on when the power switch is turned on when the surge protector is plugged into
an outlet.
• The Grounded light should be on when the surge protector is plugged into an outlet. If the light does not
come on when you turn on the surge protector, you have a ground wiring problem and you should contact an
electrician to properly ground the outlet. Connecting your surge protector to an improperly grounded outlet will
void all Audiovox warranties.
If you are using a coax cable, pass the connection through the
protected coax jacks on your surge protector. Most TV/VCR
damage can be prevented if you connect the coax cable through
the surge protector.
1. Connect the Cable/Antenna line from your source to the
INPUT jack on the surge protector.
2. Connect the coax cable from the OUTPUT jack of the surge
protector to the device you want to protect.
Sat/Coax Cable Connections
CONNECT TO
DEVICE'S COAX
JACK coax
cable
coax
cable
TV/VCR/CABLE DEVICE
TV/VCR/CABLE DEVICE
CABLE/
ANTENNA
OUTLET
CABLE/
ANTENNA
OUTLET
If you are using an Ethernet network data line, pass the
connection through the protected Ethernet jacks on your
surge protector. Most network card or modem damage can be
prevented if you connect the
CAT. 5 or CAT. 6 cable through the
surge protector.
1. Connect the CAT. 5 or CAT. 6 cable from your wall outlet to
the INPUT jack on the surge protector.
2. Connect a CAT. 5 or CAT. 6 cable into the OUTPUT jack on
the surge protector.
3. Connect the other end of the CAT. 5 or CAT. 6 cable to the jack
of the network card or modem you want to protect.
Ethernet Connections
CONNECT TO
DEVICE'S JACK
DEVICE
(network card, modem, etc.)
CAT. 5 or CAT. 6
WALL JACK
CAT. 5 or CAT. 6 cable