ACR&Artex PathFinder3 SART - Manual (Page 8)

Y1-03-0170J 5
CAUTION: Keep this SART at least 3 feet (1 meter) away from all
magnetic sources, stereo speakers and compass installations.
Installation
The SART mounting bracket should be bolted to a bulkhead using four (4)
suitable M6 (1/4") bolts. Mounting hardware for the bracket is not included.
Hardware required depends on the bulkhead material and its thickness.
Bracket mounting holes and SART mounting details are shown in figure 4.
To install the
PathFinder™
3
:

Remove SART from its packaging and check for shipping damage.

Perform the SART test (see Maintenance section for the procedure).

Select a position for SART Mounting allowing sufficient space for the
assembly.

Drill holes to dimensions shown on Figure 4.

Place bracket in position and secure to bulkhead as follows:

Remove the SART from the bracket.

Position bracket at the correct position for maximum visibility

Mark position of bracket fixing holes.

Drill holes to suit mounting fixtures.

Secure bracket to bulkhead.

Mount SART on the bracket (see figure 4).

Secure SART with Velcro strap.