Testing your beacon, Gps self testing (gnss self-test) – ACR&Artex ResQLink PLB User Manual

Page 13

Advertising
background image

Light Scheme Result

Light Meaning

GPS Downloaded Data and

Sent in Test Burst

GPS Unable to Download

Test Not Initiated: GPS

Self Test Limit Exceeded

GPS Self Testing (GNSS Self-Test)

The GPS receiver is located under the bottom front portion of

the case. It is imperative that the receiver is not obstructed

during Self-Test or activation to ensure that the GPS receiver is

acquiring your latitude (LAT) and longitude (LON) position. This

test must be performed outside with a clear view of the sky.

This beacon has enough excess battery life to perform 12 GPS

self tests over the 5 year life of the battery. Once this GPS

testing feature reaches 12 times, the feature will be disabled by

internal software.

To perform a GPS Self Test:

1. Unclip the antenna latch from the case.

2. Move antenna into the upright position

3. Depress the Test button for 5+ seconds

3 Green LEDs will flash followed by a continuous series of RED

flashes until GPS has been downloaded into the beacon. Once

valid GPS data has been obtained, a long GREEN flash will

appear followed by a flash of the Strobe Light. This indicates a

successful GPS Self Test. This will take no longer than two

minutes.

3 Red LEDs at the start of test indicates that 12 GPS test have

been performed; the test will not run.

If at the end of the GPS Self Test, a long Red light appears, this

indicates that the beacon was unable to find your GPS

coordinate.

13

6. Testing Your Beacon

Quick Tip:

A Basic Self Test will take

roughly 10 seconds to

perform and complete.

A GPS Self Test will take

roughly 45-120 seconds to

perform and complete.

Battery Witness Seal Life

If your beacon flashes an initial Amber light at the beginning of the

Self- test, this indicates that your electronic witness has been

broken and you have used more than 1 hour of battery life. While

the beacon will still operate normally in a distress situation, ACR

strongly recommends you have your battery replaced and the

electronic witness reset to ensure that you will have at least 24

hours of battery power.

Every 3

seconds

Every 3

seconds

Advertising