Acroprint timeQplus Biometric (V2) Installation - Manual (Page 19)

timeQplus BIOMETRIC™ Installation Guide 18 5 timeQplus BIOMETRIC™ Installation Guide
SALARIED EMPLOYEES:
Information required to pay salaried employees appropriately.
Time required to work per pay period.
Write value here: Hours
Automatically pay salaried employees for Holidays.
Circle one: Yes No
If ‘Yes’ specify time paid for each holiday.
Write value here: Hours
TIME CARD APPROVALS:
You may optionally choose to prevent exporting Salaried or Hourly Time Cards
that have not been approved.
Export unapproved Hourly Employee’s Time Cards.
Circle one: Yes No
Export unapproved Salaried Employee’s Time Cards.
Circle one: Yes No
DEFINE SHIFTS:
Specify a set of rules for shift times and lunch schedules. Note that
Lunch Rules may be enabled without enabling the corresponding
Shift Rules.
Note: If some terms are unfamiliar, please review the Glossary
found in the TQ100 Terminal User Manual.
Write shift name here:
Shift Rules:
Round (min) Grace (min) Dock (min)
Start AM PM
Stop AM PM
If lunch is enabled for this shift, then:
Lunch Rules:
Start AM PM Duration: minutes
End AM PM Auto After: hours
Automatically pay Holidays for this shift? Circle one: Yes No
If ‘Yes’ specify time to pay for each holiday.
Write value here: hours:min
Enter your employee data. After the employee records are entered into the software,
print the Employee Profile Report for all employees. Use the report to enroll the
employees on the TQ100 terminal using the PIN numbers from the report as ID
numbers in the TQ100.
Refer to the TQ100 Terminal User Manual, Chapter Five: Fingerprint
Registration/Enrollment for details on enrolling on the TQ100 terminal.
After an employee is enrolled on the TQ100 terminal, the employee’s template must
be linked to the employee using the Enroll Template function in the software.
Select the Employee you wish to Enroll and click the ‘Enroll Template’ button. Click
‘Next’ to continue the fingerprint enrollment process.
The following screen will appear. Select the appropriate option for the TQ100
terminal in use and click ‘Next’.