Commode assembly, Adjusting leg height additional precautions, Instructions and precautions – Activeforever Drive Padded Drop Arm Commode User Manual

Page 2

Advertising
background image

FIGURE 2

1. Before assembling seat and lid, allow toilet seat

and lid to reach room temperature if exposed to

cold. This will help prevent the seat and lid clamps

from cracking while being assembled onto

commode back cross brace.

2. To drop arm, depress release button on arm and

gently allow to drop.

3. Align the toilet seat clamps onto the back frame

rail. (Both clamps should sit outside the pail

brackets). Push down on seat until clamps snap

firmly into place.

Repeat the same process for the lid.

4. When removing the seat or lid, always remove lid

first and then the seat. To remove, grasp the back

of the lid and/or seat and lift.

5. Install commode bucket by dropping into bucket

frame.

6. Reverse to remove.

1.

Before use, adjust height of each leg to your

specific needs, making sure all legs are at the

same height. When desired height is reached, lock

legs into place by aligning buttons into proper

holes, per illustration above.

2. To be sure legs are locked into place by pushing

down on or by pulling legs.

1.

Toilet seat must be in down position before use.

Failure to do so may result in breakage of

commode and possible injury.

2. Do NOT install commode without first reading and

understanding this assembly and instruction sheet.

If you can not understand these instructions,

contact a healthcare, dealer or technical

professional before attempting to install. Otherwise,

injury or damage may occur.

3. Inspect all parts for shipping damage before

assembly. If there is shipping damage - DO NOT

USE. Contact dealer/carrier for further instructions.

4. Make certain that the height adjusting snap buttons

fully protrude through the same respective hole of

each leg extension. This will ensure that the leg

extensions are securely locked in position and an

even height is achieved (see Figure 1).

5. Ensure ALL screws, nuts and/or bolts are tightened.

6. Check the rubber tips on the leg extensions for rips,

wear or if they are missing. Immediately replace

any or all if any of these imperfections exist.

7. All four leg extensions with rubber tips MUST touch

the floor simultaneously at all times.

8. Users with limited physical strength should be

supervised or assisted while using commode.

commode assembly

instructions and precautions

Back Support

Drop Arm

Release

Button

Bucket

Drops In

FIGURE 1

adjusting leg height

additional precautions

Advertising