Activeforever Compression Stocking Aid With Heel Guide - Manual (Page 2)

Tool-Free Assembly Instructions
A. Attaching Handles to Base
1. With the notches located
on the bottom of the
handle facing away from
the base, slide the handle
into the base of the Heel
Guide
™ Compression
Stocking Aid.
2. Align the notches in the
handle with the holes in
the base of the sock aid.
3. Two screws are used per
handle and each screw
comes in two parts -
hollow and threaded.
Insert the hollow end into
the notches of the handle
and through the holes in
the top of the base. Then
insert the threaded ends
into the holes on the
bottom of the base.
Simply squeeze the
screw and hollow end
together to close.
4. Repeat steps 1-3 with the other handle.
B. Attaching Cone to Base (two screws are used)
1. With the notches on the bottom of the cone facing away from the base,
slide the cone into the base of the Heel Guide ™ .
2. Align the notches in the cone with the holes in the base of the stocking
aid. You may need to adjust the flange of the cone slightly in order to
align the notches in the cone with the holes in the base.
3. Insert the hollow end of the screws into the notches of the cone and
through the holes in the top of the base. Insert the threaded end through
the holes in the bottom of the base. Simply squeeze the screw and
hollow end together to close.
Cone Handle (2)
Base
Screws (6)
www.ActiveForever.com