Activeforever Patriot ADA Compliant Portable Pool Lift - Manual (Page 11)

11
PRO POOL LIFT
TM
–HEADREST
(OPTIONAL)
TOOLS NEEDED:
5/ 64” DRI LL BI T
PHILLIPS SCREWDRIVER
ASSEMBLY INSTRUCTIONS
1. Begin by locating all parts in the above parts list.
2. Attach the headrest pad to the support bar by slipping the
cross bar into the sewn supports on the back of the headrest
pad.
3. Adjust the height of the headrest for the user and mark the
hole locations (FIGURE 8).
4. Drill a 5/64 inch [2 mm] hole at the marked locations from
step 3.
5. Install the headrest with the supplied stainless steel screws
(FIGURE 8).
ITEM # QTY. DESCRIPTION
1 1 HEADREST PAD
2 1 HEADREST SUPPORT
3 2 1/8” x 3/4" S. S. SCREW
SAFETY & MAINTENANCE INSTRUCTIONS
Do not play on or around this lift
1. Check the PRO POOL LIFT
TM
before each use to assure there are no worn parts
and that all hardware is properly tightened. If there are any worn parts, replace
them BEFORE using the Pro Pool Lift
TM
. You can call our customer service at 1-
888-687-3552 to order any parts.
2. Aqua Creek Products, LLC lifts shall be grounded per local codes.
3. At least ONCE A WEEK, the Pro Pool Lift
TM
must be cleaned with fresh water.
Do not spray the Pro Pool Lift
TM
24v battery unit directly with any pressure.
Wipe all surfaces clean with a damp, non-abrasive cloth. When cleaning the Pro
Pool Lift
TM
, use non-abrasive soap and water. Avoid harsh chemicals and
disinfectants.
4. Always read the label instructions on any cleaner carefully before applying it to a
surface.
5. The WARNING & INTENDED USE labels on the Pro Pool Lift
TM
need to be
maintained in readable fashion. If they become unreadable or faded, please
replace the label immediately. Replacement labels are available from AQUA
CREEK PRODUCTS LLC. 1-888-687-3552.
FIGURE 8