Activeforever Phoenix S35010 Power Mobility Scooter (3 Wheel) User Manual
Page 22
22
7.5 MOVING ABOUT
!
Switch off the power with power key before moving.
Always dismount from the scooter before moving.
!
Lift the scooter by the chassis, and not by the shroud.
Lifting the scooter by the bumper could cause damage
or injury.
!
For your safety, always ask for help if required. You will
need two people when moving or lifting the scooter whole.
If you are on your own, please disassemble the scooter
before lifting. Refer to the section below.
7.6 DISASSEMBLING THE SCOOTER
The S35010 / S35015 can be disassembled into four pieces, the seat (weight 13.2 lb. /
6 kg), the front section (weight 29.5 lb. / 13.4 kg), the rear section (23.4 lb. / 10.6 kg)
and battery pack (weight 21.5 lb. / 9.8 kg), without any tools. Please follow the steps.
1.
Push the Seat Rotate Lever while pulling up on the seat to remove.
2.
Loosen the seat post knob and remove the locking pin. Then remove the upper seat
post
3.
Open the battery compartment lid and lift out the battery pack.
4.
Loosen the tiller adjustment knob and fold down the tiller and retighten knob.
5.
Lock the front wheel and tiller by pulling the wheel lock catch down.
6.
Push back on the seat post to pivot the scooter’s rear section rearward until the rear
section is standing vertically on the rear bumper.
7.
Unplug the electrical connector linking the front and rear sections.
8.
Lift the front section up until the lower pegs are no longer in contact with the curved
locking brackets on the rear section.
S35010 / S35015