Updating your tool, Troubleshooting – Actron AutoScanner® CP9575 User Manual
Page 11
11
View Data allows the following items to be viewed on the Tool:
Sensor data
Operation of switches
Operation of solenoids
Operation of relays
Multiple PIDs may be sent if vehicle is equipped with more than one
computer module (for example a powertrain control module [PCM]
and a transmission control module [TCM]. The Tool identifies them
by their identification names (ID) assigned by manufacturer (i.e. $10
or $1A). See PID Definitions for more information.
Updating Your Tool
1. Download Scanning Suite from http://www.Actron.com/downloads/.
2. Install Scanning Suite.
3. Connect USB Cable to Tool and PC.
4. Start Scanning Suite. Click on Tool Update Icon and follow in-
structions.
Troubleshooting
If a “LINK ERROR” message appears, cycle the ignition key
to the OFF position for 10 seconds, then back ON, then press
the
ENTER key. Make sure the ignition key is in the ON
not the ACCESSORY position.
If the MIL Status is ON and the MIL is not illuminated with the
engine running, then a problem exists in the MIL circuit.