Binatone FBM-311 - Manual (Page 6)

6
12.Rubber feet (Figure B)
13.Cord storage (Figure B)
BEFORE USE
Remove all package materials from the ap-
paratus and clean it as indicated in this instruc-
tion.
USER INSTRUCTION
Use of the apparatus
1. Install the apparatus on a flat horizontal sur-
face in front of a comfortable seat (chair).
2. Fill the massage apparatus with water of re-
quired temperature to the maximum level. To
enhance the effect of the massage, you may
add salt or bath oil to water.
3. Connect the apparatus to electric mains.
4. Sit down and put down feet in bath. Always put in and take
out feet from the bath in whilst in sitting position.
5. Set the switch of operation mode (3) in required position.
6. For more intense foot massage, install massage rollers (7) on the
surface for acupunctural massage (5), as shown in figure A.
7. After massage procedures, set the switch (3) in position «0»
and follow instructions in the section «Maintenance and clean-
ing».
Description of operation modes of the apparatus
Heating
Massage apparatus heats water to 40 o C, irrespective of its start-
ing temperature. Hence, you can fill with cold water. Remember,
that heating the water will take time.
Infrared radiation
Infrared radiation improves circulation in legs and relieves mus-
cular stress. Infrared radiation leads to fast cell renewal. It has an
anti-inflammatory and analgesic effect.
Magnetic field
Magnetic field provides maximum relax and stimulates circula-
tion in legs.
Vibration massage with infrared radiation
Vibration massage relives muscular stress and improves circula-
tion. Vibration massage can be used both with and without filling the
apparatus with water. Combination of infrared radiation and mas-
sage gives a very good therapeutic effect.