Acumen AiP-Y14D - Manual (Page 23)

22
The IP Speed Dome Camera supports totally four Tour Path; each Tour Path consists of up to 32
Preset Points. Please refer to the instructions below to program a Tour table.
NOTE: Before setting this function, users must pre-define at least two Preset Points.
Tour Path Setting

Tour Path
Please select the number of Tour Path to be set from the drop-down list in the top of the Tour Setup menu.

Sequential Preset Points Setting
Please setup each Preset Point of the programmed Tour Path in order, assigning a Preset Point from the <Item>
list for the specified number of Preset Point. Finally, Click on the <Apply> button to save the settings mentioned
above.
3-6-2.5 Patrol Setup
The Patrol Path Programming can be found under this path: PTZ> PTZ Advance> Patrol Setup
The IP Speed Dome Camera supports up to four Patrol Paths. Please follow the instructions below
for Patrol Path setup.
Patrol Path Setting
To setup a Patrol Path, please first select a path number from the drop-down list. Then move the cursor to the PTZ
control pane, and move the camera to a desired view (PTZ controls) as the start point of a Patrol Path. Click on the
<Start> button to start record and start programming the Cruise Path via PTZ control. When finishing programming,
click on the <End> button to quit. Then this Cruise Path will be automatically recorded.
Chapter 3-6-3 PTZ Schedule Settings
To setup PTZ scheduling, please select PTZ schedule link. Use the mouse select on the radio
button of the preset types, None, Autopan, Preset #1, Preset #2, Preset #3, and Preset #4.
Click on the hour of the calendar control to configure the preset action.