Acura 2012 RL Navigation - Manual (Page 62)

Navigation System 61
ACURA_RL KA 31SJA850
Driving to Your Destination
On the map screen, you can display
freeway exit information using the
Interface Dial. The exit info icon will
only be displayed on the
map screen if
there is any freeway exit information
available. Choose the 1/4, 1/2, or 1 mile
scale, then move the crosshairs to the
desired exit info icon and push in on the
Interface Dial. Choose a place from
the list and set it as a new destination or
waypoint.
NOTE:
To turn on “Freeway exit information”
on the
map screen, display the icon bar
and select the icon (see page 68).
Guidance Mode
When en route to a destination, you
have two display options: single-screen
mode (the factory default) and the split-
screen mode.
Single-screen mode - A map is
displayed with occasional guidance
pop-up windows as you approach a
maneuver.
Split-screen mode - The map is always
displayed on the left of the screen, and
the maneuver or direction list is
displayed on the right-hand side of the
screen.
Guidance mode can be changed in either
SETUP (see Guidance Mode on
page 109), or by accessing the icon bar
(see CHANGE GUIDANCE MODE on
page 68).
When you get near the maneuver, the
map screen changes to:
On the map screen, the location of the
maneuver is marked with a small yellow
square. The guidance window is simply
an enlargement of the area indicated by
the yellow square. After you complete
the maneuver, the display returns to a
full
map screen when the single-screen
mode is set, or to a map and direction
list screen when the split-screen mode is
set.
00 ACURA_RL_KA.book 61 ページ ２０１１年８月２６日 金曜日 午後５時８分