ACU-RITE 100S - Manual (Page 17)

14 100S General Purpose Reference Manual
Operation
To set the datum using an offset:
• Using the ABS/INCR key, select the absolute (ABS) mode. Also
check that the proper measurement (inch or mm) is selected.
• Using RAD/DIA key, select the Radius mode.
• Move the tool to a known point, i.e. the outside diameter of the
workpiece or the face of the workpiece.
• Press the ZERO key once for the axis for which you are entering a
dimension.
• Using the keypad, enter the distance from your tool’s current
location to the point you want to establish as the datum. Include a
decimal point (.) and minus (-) sign when necessary.
• Press the ZERO key for the other axis, or press ENTER to return to
the DRO display.
To set the datum at the tool’s current position:
• Touch the wheel to the edge of the workpiece.
• Make sure the absolute position is displayed (ABS).
• Press the ZERO key of the appropriate axis.
Grinding
wheel