ASRock Z68 Pro3-M - Manual (Page 24)

24
ASRock Z68 Pro3-M Motherboard
English
the red-striped side to Pin1
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 26)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Serial ATAII Connectors These three Serial ATAII
(SATA2_2: see p.2, No. 14) (SATAII) connectors support
(SATA2_3: see p.2, No. 15) SATA data cables for internal
(SATA2_4: see p.2, No. 16) storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
Serial ATA3 Connectors These two Serial ATA3 (SATA3)
(SATA3_0: see p.2, No. 10) connectors support SATA data
(SATA3_1: see p.2, No. 9) cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Serial ATA (SATA) Either end of the SATA data
Data Cable cable can be connected to the
(Optional) SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
SA
TA3_1
SA
TA3_0
SATA2_3
SATA2_2
SATA2_4