ASRock B75M R2.0 - Manual (Page 32)

32
ASRock B75M R2.0 Motherboard
English
ATX 12V Power Connector Please connect an ATX 12V
(4-pin ATX12V1) power supply to this connector.
(see p.2, No. 2)
Serial port Header This COM1 header supports a
(9-pin COM1) serial port module.
(see p.2, No. 25)
Chassis Intrusion Header This motherboard supports
(2-pin CI1) CASE OPEN detection feature
(see p.2, No. 27) that detects if the chassis cover
has been removed. This feature
requires a chassis with chassis
intrusion detection design.
1
Signal
GND
2.12 Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive fi rst. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from top to bottom to
install those required drivers. Therefore, the drivers you install can work properly.
2.13 Installing Windows ® 7 / 7 64-bit / Vista TM / Vista TM 64-bit / XP /
XP 64-bit Without RAID Functions
If you want to install Windows ® 7 / 7 64-bit / Vista TM / Vista TM 64-bit / XP / XP 64-bit
OS on your SATA / SATA2 / SATA3 HDDs without RAID functions, please follow the
procedures below according to the OS you install.
2.13.1 Installing Windows ® XP / XP 64-bit Without RAID Functions
If you want to install Windows ® XP / XP 64-bit OS on your SATA / SATA2 / SATA3
HDDs without RAID functions, please follow the steps below.
AHCI mode is not supported under Windows ® XP / XP 64-bit.