Binatone HC-430 - Manual (Page 9)

9
ENGLISH
cut length (see the table on page 12). Follow the reverse proce-
dure to remove the attachment.
Use of the hair-cutting device
1. To turn on the device, move the switch (3) to «I», which is
shown on the casing panel. For turbo mode switch it to
“TURBO”.
2. To make the haircut uniform and even, move the clipper slowly
and comb the hair frequently with the barber comb (12) to
remove the cut hairs and to check for uneven locks.
3. Hold the clipper so that the cutting edge points upwards; begin
cutting hair at the center part of the neck base (see Figure
3b).
4. When finished clipping, turn the clipper off by pressing the 0/
I/Turbo switch (3).
5. On how to make a haircut see section “Useful tips”.
Accumulator maintenance
To keep the optimum operational condition of the battery, the
hair-cutting device battery should be completely discharged from
time to time. Thereafter the device should be completely recharged
by using the adapter (5). This keeps the batteries in good condi-
tion and able to take a full charge.
Troubleshooting
If the device fails to charge, follow these steps before bringing
the device to a certified service center.
1. Check the socket is not damaged. For this purpose, plug in
another device and turn it on.
2. Make sure the power supply in your house operates in a
routine mode and is not disconnected.
3. Make sure the power adapter (5) does not have any visible
damages, the device is connected to the adapter properly,
and the battery charging indicator (4) is lit.
CLEANING AND CARE
Cleaning
After each hair-cutting, clean the cutting
head of the device using a special brush (15)
or under running water .
1. Turn off the device and take it from the charg-
ing base (5).
2. Remove any hair-cutting attachments from the device and
carefully clean it using the brush (15). You can also do it under
running water.
3. Remove the used cutting head (2) from the device and re-
move all hair using the brush (15) or under running water.
4. Wipe the device casing with a damp lint free cloth or wash it
under running water .