Binatone CD-6800 - Manual (Page 6)

6
Feet installation (for CD-6800, CD-6810)
For floor installation feet must be attached to the dryer. To
attach the feet use the screws that are included in mounting hard-
ware.
Installation of the models with variable
number of levels (CD-6825, CD-6830)
CD-6825, CD-6830 models are equipped with folding sec-
tions, that can be installed according to your choice:
CD-6825 – 1 level of drying, 2 folding sections with 6 rails
each (12 rails for drying).
CD-6830 – 3 levels of drying, 6 folding sections with 6 rails
each (36 rails for drying).
Install the folding sections you need by fixing them with locking
holders.
INSTRUCTIONS ON USE
Use
1. Carefully put or hang linen, towels or clothes
on the dryer:
Models CD-6800, CD-6810 allow only ver-
tical arrangement of linen.
Models CD-6820, CD-6825, CD-6830 allow
vertical as well as horizontal arrangement of
linen. Horizontal drying is the fastest way to dry
linen.
Warning: carefully hang linen and straighten folds each
time. Linen subject to colour-bleed and fabrics with
low temperature of drying should be hung or put on
the lowest level of the dryer. Thoroughly straighten all
the folds not to defect cloth handle, spoil the colour or
dye another drying clothes. To prevent deformation of
the clothes made of thin fabrics, silk or wool, it is
recommended to dry them in a horizontal position and
with all folds carefully straightened.
2. Connect the appliance to the electric socket the voltage of
which complies with the voltage indicated on the rating plate of
the appliance.
3. Set the operation mode switch (2) to the required position: «I»
(«On»). The indicator light will come on to show that the heat-
ing elements are turned on and the process of heating started.
4. In a short while the dryer reaches the required operating
temperature.
5. After use turn the appliance off by setting the operation mode
switch (2) to «O», and unplug the dryer from the electric
power socket.