Garmin GNC 250 - Manual (Page 37)

The scheduler function will display reminder messages after a certain elapsed time
such as Change oil, Switch fuel tanks, Overhaul, etc. For example, if you enter ‘Change Oil’
to be displayed in 30 hours, the message ‘Change Oil’ will be displayed after the GNC 250
has been on in Normal operating mode for 30 hours. After appearing, the message will be
displayed each time the GNC 250 is turned on until it is changed or deleted.
To enter a scheduled message:
1. Press
N
and rotate
O
to display NAV Menu 2.
2. Press
C
twice and rotate
O
until ‘Scheduler?’ is highlighted.
3. Press E .
4. Rotate
O
to highlight the message you would like to edit. To delete, press
\
,
then
E
.
5. Use
K
and
O
to enter the message. Press
E
.
6. Use K and O to set the elapsed time until the message is displayed, in hours and
minutes, up to 99 hours and 59 minutes (this time is cumulative and counts whenever
the GNC 250 is on in normal operating mode).
7. Press E .
You may edit another scheduled message by repeating steps 3, 4 and 5, or if you are fin-
ished, press
C.
27
REFERENCE
WPT Key Overview
The scrolling arrow prompt indicates which direc-
tion to scroll to view additional listings.
The scheduled message will appear after the timer
expires and after the GNC 250 is powered up
until the message is changed.
Entering a scheduled message.
SECTION
1
NAV KEY
NAV Menu 2
Scheduler
250 real 7/14/98 9:32 AM Page 27