Garmin GPSMAP 232 - Manual (Page 95)

85
Appendix H
Unit Installation
Mounting the GPSMAP 182/182C/232 Unit
The GPSMAP 182/182C/232’s compact, waterproof case is suitable for mounting in exposed
locations or at the nav station. The unit comes with a gimbal bracket that can be used for surface or
overhead mounting. When choosing a location for the display unit, make sure you consider the follow-
ing conditions:
• There should be at least a 3” (7 cm) clearance behind the case to allow connection of the
antenna (external antenna only), power/data cables.
• The mounting surface should be heavy enough to support the unit and protect it from excessive
vibration and shock.
• For GPSMAP 182/182C/232 unit’s with the built-in internal bail mount antenna, it should be
mounted in a location that has the clearest, most unobstructed view of the sky in all directions to
ensure the best reception. Avoid mounting the unit where it will be blocked by the boat’s superstruc-
ture, a radar arch, or mast.
The temperature range for the GPSMAP 182/182C/232 is 5°F to 158°F (-15°C to 70°C).
Extended exposure to temperatures exceeding this range (in storage or operating
conditions) may cause failure of the LCD screen. This type of failure and related conse-
quences are NOT covered by the manufacturer’s limited warranty.
To install the GPSMAP 182/182C/232 unit:
1. Place the mounting bracket in the desired location.
2. Mark and drill the four mounting holes for the fastener you are using.
3. Fasten the bracket to the surface using the appropriate fastener.
4. Insert the GPSMAP 182/182C/232 into the mounting bracket. The bracket is designed for a tight fit
to provide additional support when swiveling the unit.
5. Screw the two mounting knobs through the bracket and into the display case.
6. Connect the power/data and antenna cables (external antenna only) to the back of the unit, making
sure the locking rings are fully tightened on both connectors.
