Garmin GVN 52 - Manual (Page 47)

GVN 52 Owner’s Manual 
a
PPendiX
a
ppendiX
Using the Remote Control
The remote control uses two AAA batteries. Do not mix
old and new batteries together. If the remote does not
work, install fresh batteries. If this does not correct the
problem, you can re-pair the remote control with the
GVN 52. You must also follow this procedure to use a
replacement remote control.
To pair your remote with the GVN 52:
1..Press.and.hold.the. Thumb Stick .and.the. 0 .key.on.
the.remote.for.10.seconds.
2..Follow.the.instructions.
on.the.screen;.enter.the.
correct.numbers..The.
remote.control.pairs.with.
the.GVN.52.
Updating the Software and Map Data
To update the navigation system software, you must
have an SD card, an SD card reader, and an Internet
connection.
To update the navigation software:
1.. Go.to .www.garmin.com/support/download.jsp ..
2.. Click. Additional Software .
3.. Select. GVN 52 .from.the.list.of.products.
2.. Click. Download .next.to.the.navigation.system.software..
3.. Read.and.agree.to.the.terms..Click. Download ..
4.. Select. Save ..Then.save.the.update.onto.an.SD.card.
5.. Insert.the.SD.card.into.the.side.of.the.GVN.52..Make.
sure.the.system.is.powered.on..Your.software.is.updated.
automatically.
You can purchase map data updates from Garmin. Check
www.garmin.com/unlock/update.jsp to see if an update
for your map software is available.