Garmin GPSMAP 496 - Manual (Page 11)

GPSMAP 496 Owner’s Manual 3
Getting Started > Turning On the GPSMAP 496
Turning On the GPSMAP 496
The first time you turn on your new GPSMAP 496, the receiver
must collect satellite data and establish its present location. To
ensure proper initialization, the GPSMAP 496 is shipped from the
factory in AutoLocate mode, which allows the receiver to “find
itself” anywhere in the world. Before you turn on the unit to start
initialization, be sure that the antenna is rotated up as shown on
page 1 , and it has a clear and unobstructed view of the sky to receive
satellite signals.
To turn the GPSMAP 496 on and off:
1. Press and hold the POWER key. When the unit turns on, a tone
sounds and the Warning Page appears.
Warning Page
2. Read and be sure you understand the warning. Press ENTER to
continue.
3. To turn off the GPSMAP 496, press and hold the POWER key
again.
Adjusting the Backlight and Volume
The poWEr key controls the 10 level backlight and volume of
the optional headphone jack or external speaker with vehicle power
cable.
To adjust the backlight level or volume:
1. Press and quickly release the POWER key.
2. Press the ROCKER up to increase the brightness or down to
decrease. Press right to raise the volume or left to lower.
3. Press ENTER or QUIT to close the Backlight/Volume adjustment
window. Press MENU to view the options menu.
Backlight
adjustment slder
Volume
adjustment slder
Battery time remaining
and power source
ndcator