Garmin GNS 430 - Manual (Page 19)

GNS 430(A) Pilot’s Guide and Reference 190-00140-00 Rev. P 1-11
SECTION 1
INTRODUCTION
Map Page
After the GNS 430 acquires satellites and computes
a position, the Map Page (Figure 1-14) appears
automatically.
Figure 1-14 Map Page
Present Position
Desired Track
Data Fields Map Range
Map Display
The Map Page displays the present position (using an
airplane symbol) relative to nearby airports, VORs, NDBs,
intersections, user waypoints, and airspace boundaries.
The route is displayed as a solid line.
Data fields for destination waypoint (WPT), distance
to waypoint (DIS), desired track (DTK), and ground speed
(GS) appear on the right-hand side of the display. These
fields are user selectable (Section 3.4, Selecting Desired
On-screen Data) to allow the pilot to configure the unit.
Available settings include: altitude, bearing, enroute safe
altitude, estimated time of arrival, minimum safe altitude,
and ground track.
A Map Setup Page is provided to designate the
maximum range at which each map feature appears.
These settings provide an automatic decluttering of the
map (based upon preferences) while adjusting the range.
See Section 14.3 for definitions of these navigation terms.
While viewing the Map Page, the pilot can quickly
declutter and remove many of the background map details
by pressing the CLR Key (repeatedly) until the desired
detail is depicted.
To change the map range, press the up arrow (to zoom
out) or the down arrow (to zoom in) of the RNG (map
range) Key. The current map range is depicted in the
lower left corner of the Map Display.
Direct-to Navigation
The GNS 430 can use direct point-to-point navigation
to provide guidance from takeoff to touchdown, even
in the IFR environment. Once a destination is selected,
the unit provides speed, course, and distance data based
upon a direct course from the present position to the
destination. A destination can be selected from any page
with the Direct-to Key.
To select a direct-to destination:
1) Press the Direct-to Key. The Select Direct-to
Waypoint Page appears with the destination
field highlighted.
2) Turn the small right knob to enter the first
letter of the destination waypoint identifier.
The destination waypoint may be an airport,
VOR, NDB, intersection, or user waypoint,
as long as it is in the database or stored in
memory as a user waypoint.
3) Turn the large right knob to the right to move
the cursor to the next character position.
4) Repeat steps 2 and 3 to spell out the rest of
the waypoint identifier (Figure 1-15).
Figure 1-15 Direct-to Waypoint Page