Appendix – Garmin GPSMAP 230 User Manual

Page 79

Advertising
background image

67

SECTION

A

APPENDIX

Installation

Installing the GPSMAP 230

The GPSMAP 180 must be properly installed according to the following instruc-

tions to get the best possible performance. The GPS antenna should be installed
first, followed by the display unit. To complete the installation, you’ll need the
appropriate fasteners for your installation, and a 1” x 14-thread marine antenna
mount available at most marine dealers.

Mounting the GPS antenna

The antenna should be mounted in a location that has a clear, unobstructed

view of the sky in all directions to ensure the best reception. Avoid mounting the
antenna where it will be shaded by the boat’s superstructure, a radome antenna, or
mast. Sailboat users should avoid mounting the antenna high on the mast to pre-
vent inaccurate speed readings caused by excessive heeling. Most marine VHF and
loran antennas will not seriously degrade the GPS antenna’s reception. Never paint
the antenna or clean it with harsh solvents.

The GARMIN antenna screws directly onto any standard 1” x 14-thread antenna

mount. If you need to raise the antenna to avoid shading, try using a 1” x 14-
thread extension mast available at most marine dealers.

To install the GPS antenna:

1. Screw the antenna directly onto the 1” x 14-thread mount.

2. Route the cable to the mounting location of the display unit. Use the appropriate tie-

wraps, escutcheon plates, and sealant to secure the cable along the route and through
any bulkhead or deck.

3. Once the GPSMAP unit has been installed, connect the cable to the antenna connector

on the back of the display unit. Make sure that you turn the antenna-connector locking
ring 1/4 turn clockwise to lock the cable into place.

It is possible to route the coaxial cable either through, or out-
side the antenna mount. The BNC connector on the coaxial
cable can be removed, and the coaxial cable shortned to ease
installation. If the BNC connector is removed, it must be
replaced with a new BNC connector.

update on 230.qxd 1/12/00 11:23 AM Page 67

Advertising