Garmin StreetPilot 7200 User Manual

Streetpilot, Set up and go, Getting ready

Advertising
background image

Attach the mounting plate to your dashboard.

1. Clean the area where you want to place the mount with

rubbing alcohol. Dry with a clean dry cloth.

2. Remove the liner from the bottom of the mounting plate.
3. Place the mounting plate in the selected location.
4. Bend the edges of the mounting plate to fit the surface.

Attach the mounting cradle to the StreetPilot.

1. Place the two tabs on the cradle into the two grooves on the top of the StreetPilot. (A)
2. Swing the cradle forward so that the StreetPilot is fully seated in the cradle. (B)
3. Slide the cradle’s locking lever to the right (locked).

Slide the mounting cradle into the base on the mounting plate.

1. Slide the bottom of the mounting cradle into the mounting base.
2. Slide the base’s locking lever to the right (locked).
3. Plug the power cable into a 12-Volt receptacle in your vehicle.
4. Route the cable so it does not interfere with vehicle operation.

Getting Ready

Congratulations on purchasing a StreetPilot 7200/7500! Follow the mounting and setup steps in this guide to get started. See the back

of this sheet to start using your StreetPilot. For more information, see the owner’s manual that came in the box.

What’s in the Box

Remove the following items from the box. You will need these items to mount the StreetPilot and get started.

Remote

Control

MENU

MAP

BACK

SPEAK

IN

OUT

PAGE

ZOOM

1

ABC

2

DEF

3

GHI

4

JKL

5

MNO

6

PQRS

7

TUV

8

WXYZ

9

0

VOL

Mounting Cradle with

Power Cable

Mounting Base on

Mounting Plate

7200/7500 Unit

Configure your StreetPilot

If necessary, turn the key in the ignition to apply power to the StreetPilot. Follow the screen prompts to set up your

StreetPilot:

Select a language. Touch

Next

.

Touch a time zone. Touch

Next

.

Touch

Done

.

Select an option. Touch

Next

.

Select an option. Touch

Next

.

Wait a few minutes.

StreetPilot

®

7200/7500

Warning

: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the StreetPilot 7200/7500 installed to place and

secure the device so it does not interfere with the vehicle operating controls and safety devices, obstruct the driver’s view of driving conditions,

or cause personal injury in the event of an accident.

© Copyright 2005–2006 Garmin Ltd. or its subsidiaries

May 2006

190-00454-01 Rev. B

Printed in Taiwan

set up and go!

Sliding the Mount in the Base

Power button

Locking lever

StreetPilot

Puck

Mounting

cradle

Attaching the Cradle to the StreetPilot

A

B

Advertising